Cooperemmerton• Friday 28th of June 2024, 11:47:40 AM
Now dance, now dance
Kiaraking• Tuesday 25th of June 2024, 01:38:15 AM
A. No need to unclip the power switch plate, as it can be held up with a screwdriver tip underneath when needed. - B. Battery type needed is 42x14mm 4/5 AAA 1.2V, NiMH such as a PANASONIC HHR-120AA. - C. Battery direction is minus at bottom of toothbrush (as noted) - D. Soldering the minus/bottom side of battery using it's tap can be tricky. I soldered a short wire to the board first, then bent it towards the bottom of the battery, trim cut and soldered it directly to it. That is easier, than using the battery tap, especially, when you soldering tip is too big. - - - Maybe you could supply a list of needed tools, too. In any case THANX MUCH!
Kalvinlabuik• Sunday 23rd of June 2024, 09:12:34 AM
All Interesting Comments:
3 comments
Now dance, now dance
A. No need to unclip the power switch plate, as it can be held up with a screwdriver tip underneath when needed. - B. Battery type needed is 42x14mm 4/5 AAA 1.2V, NiMH such as a PANASONIC HHR-120AA. - C. Battery direction is minus at bottom of toothbrush (as noted) - D. Soldering the minus/bottom side of battery using it's tap can be tricky. I soldered a short wire to the board first, then bent it towards the bottom of the battery, trim cut and soldered it directly to it. That is easier, than using the battery tap, especially, when you soldering tip is too big. - - - Maybe you could supply a list of needed tools, too. In any case THANX MUCH!
(It's a tank)